High-precision determination of residual stress of polycrystalline coatings using optimised XRD-sin2ψ technique

[摘要] The aim of the research is to optimise the XRD-sin(2)psi technique in order to perform high precision measurement of surface residual stress. Residual stresses existing in most hard coatings have significant influence on the adhesion, mechanical properties and tribological performance. In the XRD-sin(2)psi stress measurement, the residual stress value is determined through a linear regression between two parameters derived from experimentally measured diffraction angle (2 theta). Thus, the precision coefficient (R-2) of the linear regression reflects the accuracy of the stress measurement, which depends strongly on how precise the 2 theta values are measured out of a group of very broad diffraction peaks. In this research, XRD experiments were conducted on a number of samples, including an electron beam evaporated ZrO2 based thermal barrier coating, several magnetron sputtered transition metal nitride coatings, and shot-peened superalloy components. In each case, the diffraction peak position was determined using different methods, namely, the maximum intensity (I-max) method, the middle point of half maximum (MPHM) intensity method, the gravity centre method, and the parabolic approaching method. The results reveal that the R-2 values varied between 0.25 and 0.99, depending on both the tested materials and the method of the 2 theta value determination. The parabolic approaching method showed the best linear regression with R-2 = 0.93 +/- 0.07, leading to high precision of the determined residual stress value in all cases; both the MPHM (R-2 = 0.86 +/- 0.16) and gravity centre (R-2 = 0.91 +/- 0.11) methods also gave good results in most cases; and the I-max method (R-2 = 0.71 +/- 0.27) exhibited substantial uncertainty depending on the nature of individual XRD scans. (C) 2010 Elsevier B.V. All rights reserved.

[发布日期] 2010-11-25

[效力级别]  Proceedings Paper

[关键词] Residual stress measurement;X-ray diffraction;PVD hard coatings;Thermal barrier coatings;Shot peening hardening