Improving machining performance using alumina powder-added dielectric during electrical discharge machining (EDM)

[摘要] Alumina powder was added to dielectric fluid during Electrical discharge machining (EDM) of AISI 304 steel. The main machining parameters of current (A), tool diameter (mm) and powder concentration (g/L) were chosen to determine the EDM machining characteristics of material removal rate (MRR), tool wear rate (TWR) and surface roughness (Ra). This work adopted two-level full factorial experiments. The significant factors that affect the MRR and tool TWR are current, tool diameter and powder concentration. The MRR increases when the current and tool diameter are higher. The presence of powder concentration also increases the MRR. The higher current used and the presence of powder concentration increase the TWR. Meanwhile, a smaller tool diameter gives higher value of TWR. Current and powder concentration are the significant factors to determine the surface roughness of work surfaces. Higher current applied gives high surface roughness, but higher powder concentration gives improved surface finish.

[发布机构] Department of Manufacturing and Materials Engineering, International Islamic University Malaysia, Jalan Gombak, Kuala Lumpur; 53100, Malaysia^1;Department of Mechanical Engineering, International Islamic University Malaysia, Jalan Gombak, Kuala Lumpur; 53100, Malaysia^2

[效力级别] 无线电电子学 [学科分类] 航空航天科学

[关键词] Electrical discharge machining;Full factorial experiment;Machining characteristics;Machining parameters;Machining performance;Material removal rate;Surface finishes;Surface roughness (Ra)