已收录 272983 条政策
 政策提纲
  • 暂无提纲
Static behavior of the weld in the joint of the steel support element using experiment and numerical modeling
[摘要] The paper is focused on the numerical modeling of welded steel bearing elements using commercial software system ANSYS, which is based on the finite element method - FEM. It is important to check and compare the results of FEM analysis with the results of physical verification test, in which the real behavior of the bearing element can be observed. The results of the comparison can be used for calibration of the computational model. The article deals with the physical test of steel supporting elements, whose main purpose is obtaining of material, geometry and strength characteristics of the fillet and butt welds including heat affected zone in the basic material of welded steel bearing element. The pressure test was performed during the experiment, wherein the total load value and the corresponding deformation of the specimens under the load was monitored. Obtained data were used for the calibration of numerical models of test samples and they are necessary for further stress and strain analysis of steel supporting elements.
[发布日期]  [发布机构] Department of Structural Mechanics, Faculty of Civil Engineering, VSB-Technical University of Ostrava, Ludvika Podeste 1875/17, Ostrava - Poruba; 708 33, Czech Republic^1
[效力级别] 运输工程 [学科分类] 
[关键词] Bearing elements;Commercial software systems;Computational model;Pressure tests;Static behaviors;Strength characteristics;Stress and strain analysis;Verification tests [时效性] 
   浏览次数:33      统一登录查看全文      激活码登录查看全文