With increasing functional demands of patients undergoing total knee arthroplasty, mobile-bearing (MB) implants were developed in an attempt to increase the functional outcome of such patients. In theory, with MB implants, the self-alignment should reduce the rate of lateral release of the patella, which is usually performed to optimise patellofemoral mechanics. This study reports on the lateral release rates for the P.F.C. Sigma® MB posterior-stabilised total knee replacement (TKR) implant compared with its fixed-bearing (FB) equivalent.
A total of 352 patients undergoing TKR were randomly allocated to receive either MB (176 knees) or FB (176 knees) posterior-stabilised TKR. Further sub-randomisation into patellar resurfacing or retention was performed for both designs. The need for lateral patellar release was assessed during surgery using a ‘no thumb technique’, and after releasing the tourniquet if indicated.
The lateral release rate was the same for FB (10 %) and MB implants (10 %) (p = 0.9). However, patellar resurfacing resulted in lower lateral release rates when compared to patellar retention (6 vs 14 %; p = 0.0179) especially in MB implants (3 %).
It has been previously reported that alterations to the design of the P.F.C. system with a more anatomical trochlea in the femoral component improved patellar tracking. The addition of a rotating platform tibial component to the P.F.C. Sigma system has, on its own, had no impact on the lateral release rate in this study. Optimising patellar geometry by patellar resurfacing appears more important than tibial-bearing design. Although MB implants appear to reduce the need for lateral release in the P.F.C. Sigma Rotating Platform, this only occurs when the patellar geometry has been optimised with patellar resurfacing.
Level 2.
