Synthesis of Products, Processes and Control for Dimensional Quality in Reconfigurable Assembly Systems.

[摘要] Reconfigurable systems and tools have given manufacturers the possibility to quickly adapt to changes in the market place. Such systems allow the production of different products with simple and quick reconfiguration. Another advantage of reconfigurable systems is that the accuracy of the tools provides a unique opportunity to compensate errors and deviations as they occur along the manufacturing system, hence improving product quality. This dissertation deals with the design of products, processes and controllers to enhance dimensional quality of products produced in reconfigurable assembly processes. The successful synthesis of these topics will lead to new levels of quality and responsiveness.Fundamental research has been conducted in dimensional control of reconfigurable multistation assembly systems. This includes three topics related to the design of products, processes, and controls. These are:oDevelopment of feedforward controllers: Feedforward controllers allow deviation compensation on a part-by-part basis using reconfigurable tools. The control actions are obtained through the combination of multistation assembly models, in-line measurements (used to measure deviations along the process), and the characteristics and requirements of products/processes, in an optimization framework. Simulation results show that the proposed control approach is effective on reducing variation.oOptimal selection and distribution of actuators in multistation assembly processes:The availability of reconfigurable tools in the process enables error correction; however, it is too expensive to install at every location. The selection and distribution of the actuators is focused on cost effectively reducing variation in multistation assembly processes. Simulations results prove that dimensional variation could be significantly reduced through an appropriate distribution of actuators.oRobust fixture design for a product family assembled in a reconfigurable multistation line: The assembly of a product family in a reconfigurable line demands fixtures sharing across products. The sharing impacts the products robustness to fixture variation due to frequent systems reconfiguration andtradeoffs made in the design of fixtures to accommodate the family in the single system. A robust fixture layout for a product family is achieved by reducing the combined sensitivity of the whole family to fixture variation and considering product and process constraints.

[发布机构] University of Michigan

[效力级别] Multisation Assembly

[关键词] Dimensional Control;Multisation Assembly;Optimal Actuator Placement;Product Family Design;Robust Design;Mechanical Engineering;Engineering;Mechanical Engineering