Shrinkage and flexibilty behaviour of Bitumen Stabilised Materials

[摘要] ENGLISH ABSTRACT: The increasing awareness of climate change causes a growing interest in pavement rehabilitation. Pavement rehabilitation by in-situ stabilisation with bitumen reduces the extraction of natural aggregate resources while enhancing flexibility and durability properties, which lowers maintenance costs over the design-life of the pavement structure. Incorporating Bitumen Stabilised Materials (BSMs) into a pavement structure can therefore have economic and environmental benefits, but more research is needed to fully understand the behaviour and potential of these materials. Stabilising materials with bitumen provides useful properties to pavement layers. The 'TG2 2nd Edition, Bitumen Stabilised Materials was published by the Academy of South Africa in May 2009, which provides a good understanding of the usage of Bitumen Stabilised Materials (BSMs). However, the shrinkage and flexible behaviour of these materials are still not fully understood and therefore more research on these materials is needed. The aim of this project is thus to determine the shrinkage and flexible behaviour of BSMs to incorporate these behavioural types in the revised design method for flexible pavements in the SAPDM. In addition, the influence of several additives on the shrinkage and flexible behaviour of BSMs have been evaluated to get an improved understanding of these properties. The additives included cement (1% and 2% content) and both bitumen emulsion (0.9% and 2.4% content) and foamed bitumen (only 2.4% content). Two linear shrinkage testing methods have been designed to test the shrinkage potential of BSMs, including a beam testing method and a cylindrical testing method. Based on the usage of the shrinkage measurements the applicable method can be used to determine the shrinkage potential of a BSM. The flexibility is a more complex property and was tested using a simple monotonic beam test. The strain-at-break parameter obtained from this test provided an indication of the material flexibility. Slight differences in the trends were observed between beam and cylindrical shrinkage due to specimen geometry, exposed surface area and shrinkage testing direction. Beam specimens initially show swelling when bitumen is added to the mixture and shrinks thereafter. Cylindrical specimens on the other hand show initial shrinkage followed by a slight length increase, where after shrinkage continues. The additives had the same influence on the shrinkage for both the beam and cylindrical specimens. Although all shrinkage measurements were small, an increase in bitumen reduced shrinkage and an increase in cement increased shrinkage. Stabilisation with foamed bitumen rather than bitumen emulsion proved to show less shrinkage, but only incombination with 2% cement.The strain-at-break, dissipated energy and material stiffness calculated from the monotonicbeam tests provided a good indication of the flexibility behaviour of BSMs. Higher bitumencontent increased the flexibility potential and an increase in cement decreased the flexibilitypotential of BSMs.This project has provided good insight on both the shrinkage and flexibility behaviour of BSMs,which can be used in the revised copy of the SAPDM. Increased bitumen contents decreasesthe shrinkage potential and increases the flexibility of a BSM. Increased cement contents on theother hand, increases shrinkage and decreases flexibility of BSMs. The correct combination ofcement and bitumen in a BSM can thus provide a material with the wanted flexibility whilekeeping the shrinkage to a minimum.

[发布机构] Stellenbosch University