Reduction of seawall overtopping at the Strand

[摘要] ENGLISH ABSTRACT: The Strand is located within False Bay and frequently encounters large quantities of wave overtopping over the coastal defences. This results in the damage of property and infrastructure and causes streets to be flooded. Physical modelling tests were done by a consultancy firm to determine a solution by making use of a recurve structure at the back of the beach.This study is an expansion of the previous physical modelling that was done and focuses on several factors that were not tested by the consultancy firm that could have an influence on the overtopping rate and provide additional information on the recurve design. These tests were: (i) the effectiveness of the proposed recurve wall design in reducing overtopping was compared to a vertical wall; (ii) the influence that modifications to the beach profile such as the beach slope, beach width and beach level have on the overtopping rate; and (iii) the sensitivity of overtopping to changes in wave period was tested. The information gathered from these tests was used to propose a possible solution for the Strand.Numerical modelling was done with Delft3D-Wave to determine the wave height at the back of the beach using a nested grid. The waves at the Strand are depth limited and therefore very sensitive to changes in water level. By altering the beach level the model showed how the significant wave height at the back of the beach changes. First estimates of overtopping were determined using the relevant empirical calculations from the EuroTop Manual 2007 for a vertical seawall. No estimate could be made for the recurve wall since it did not fall in the valid range of the equations.From the physical modelling it was found that the overtopping reduced significantly from a vertical to a recurve seawall by a factor of about 50% depending on the wall height. All the prediction methods tested proved to be accurate in estimating the overtopping when the ratio of freeboard to significant wave height was ≤1.83. For non-breaking wave conditions the beach profiles that were gently sloped (1:50) and wide produced more overtopping than the beach profiles that were steep (1:10) and narrow. Increasing the beach level only decreased the overtopping if the water depth was shallow enough to cause the waves to break before they reached the back of the beach. Overtopping was found to increase with longer wave periods until the wave period became too long and the waves broke offshore which resulted in the overtopping decreasing.Possible solutions to overtopping were proposed based on two beach levels and the implementation of a recurve seawall. Revised crest levels for the wall were made along the length of the beach for both the 1:20 and 1:100 year water levels.

[发布机构] Stellenbosch University