Simulation of tribological interactions in bonded particle-solid contacts

[摘要] ENGLISH ABSTRACT:In this study, tool forces from rock cutting tests were numerically simulated through a discrete element method (DEM) in association with PFC3D™. Tribological interactions such as contact, shearing, fracturing, friction and wear were presented during these cutting simulations. Particle assemblies, representing Paarl granite and Sandstone-2, were created in PFC3D™ through a material-genesis procedure. The macro-properties of these particle assemblies, namely Young's modulus, Poisson's ratio, uniaxial and triaxial compressive strength and Brazilian tensile strength, were calibrated by modelling the uniaxial and triaxial compressive strength test and the Brazilian tensile strength test. The calibration was done through adjustment of the micro-properties of the assembly, namely the stiffness and strength parameters of the particles and bonds. The influence of particle size on the calibration was also investigated. These assemblies were used in the rock cutting tests. Results suggested that DEM can reproduce the damage formation during calibration tests successfully. From the results obtained from the calibration tests, it was also concluded that particle size is not a free parameter but influences the macro-properties greatly.Different rock cutting tools were simulated, namely point-attack (conical) picks, chisel-shaped tools and button-shaped tools. The numerical cutting tools were treated as rigid walls to simplify the simulation and the tool forces were not influenced by wear. In each simulation the cutting tools advanced at a constant velocity. The tool forces acting on the cutting tool, in three orthogonal directions, were recorded during the numerical simulations and the peak cutting forces were predicted by theoretical equations. The damage to the Paarl granite and Sandstone-2 assemblies was revealed as broken bonds, which merge into microscopic fractures. The mean peak cutting forces of sharp cutting tools obtained from numerical, theoretical and experimental models (from the literature) were compared. Finally the influence of factors, including wear on the tool and depth of cut, on the value of tool forces was also investigated.The results from the rock cutting tests revealed that the correlation between the numerical and the experimental models as well as the theoretical and experimental models was not strong when using sharp point-attack and chisel-shaped picks. It was concluded that the influence of wear plays a substantial part in the cutting process and it has to be included during the numerical simulation for the results to be accurate and verifiable. This study also found that there is a non-linear increase in tool forces with an increase in depth of cut, since the contact area increases. At larger cutting depths, chip formation also generally increased and therefore damage to the sample as well as wear on the cutting tool will be minimized at shallow cutting depths. Overall this study concludes that DEM are capable of simulating calibration methods and rock cutting processes with different cutting tools and producing results which are verifiable with experimental data. Therefore numerical prediction of tool forces will allow the design of efficient cutting systems and the operational parameters as well as the performance prediction of excavation machines.

[发布机构] Stellenbosch University