Type i and type ii error associated with verification and confirmation measurements.

[摘要] DOE M 474.1 states that 'For Category I and II items, the acceptance/rejection criteria for verification measurements and, where possible, for confirmation measurements must be based on the standard deviation for the measurement method under operating conditions.' Determination of the acceptance/rejection criteria for confirmation and verification measurements may involve null and alternative hypothesis testing. The specific values used for computing the appropriate test statistics are dependent on the desired type I and II errors. If hypothesis testing is applied to a verification measurement (such as verification measurement signal interpretation equals nuclear material book value), then the successful application of hypothesis testing and accurate determination of type I and type II error is dependent on the existing statistical assumptions. This paper discusses some common statistical assumptions that may be used in support of confirmation and verification measurements. The implications of these assumptions on type I and II error are briefly analyzed. Suggestions for validating the desired type I and II error for confirmation and verification measurements are provided. This paper, by providing an introduction to some common statistical assumptions and the associated implications on error, aids safeguards professionals in their ability to determine the validity on the statistical modes that support their verification and confirmation measurement programs.

[发布机构] Technical Information Center Oak Ridge Tennessee

[学科分类] 工程和技术（综合）

[关键词] Errors;Verification;Safeguards;Measurements;Confirmation